The drain pump empties the tub before the spin cycle. A blocked pump or a failed motor leaves standing water and stops the cycle, and the machine will not spin while water remains.
Appliance part
Washer Suspension Rods
Suspension rods hold the tub and absorb spin vibration on top-loaders.
Worn rods let the tub bang against the cabinet, and the machine walks during spin.
Symptoms of a failed washer suspension rods
- Banging during spin
- Washer walks or shakes
- Tub tilts or sags when empty
Fitment
Rods are sold in sets of four for most models; match the model and cabinet size.
Before you buy
Confirm the model and serial plate before ordering — two parts can look identical and still not fit. If you would rather not fit it yourself, request a repair quote and we will route it to an independent technician.
Guides that cover this part
Related parts
The inlet valve controls hot and cold fill. A clogged screen slows the fill; a failed solenoid lets the washer overfill or not fill at all.
The lid switch tells the control the lid is closed before a spin. A failed switch stops the spin and drain on top-loaders even though the machine fills and agitates normally.
The boot seals the door to the tub on a front-loader. Tears and mould cause leaks and odour, and a boot that is not seated correctly will leak on every spin.
Many top-load washers use a belt between the motor and transmission. A glazed, stretched or broken belt causes a drum that will not agitate or spin while the motor runs.