The gasket seals the door against the cabinet. A hardened or torn seal lets warm, humid air in, which causes frost, constant running and condensation.
Appliance part
Evaporator Fan Motor
The evaporator fan moves cold air from the coil into the cabinet.
A failed motor leaves the compressor running but the cabinet warm, and it often makes a bearing noise before it stops.
Symptoms of a failed evaporator fan motor
- Freezer cold at the back only
- No airflow inside the cabinet
- Whining or grinding from the rear wall
Fitment
Match the motor voltage, shaft length and connector; some assemblies include the blade and bracket.
Before you buy
Confirm the model and serial plate before ordering — two parts can look identical and still not fit. If you would rather not fit it yourself, request a repair quote and we will route it to an independent technician.
Guides that cover this part
Related parts
The defrost heater melts frost off the evaporator during the defrost cycle. If it fails, ice builds up, airflow stops and the freezer warms.
The start relay gives the compressor a momentary boost to start. When it fails, the compressor clicks, hums briefly and trips, and the cabinet warms.
The ice maker fills, freezes and dumps cubes on a timer. Failures show up as no ice, small or hollow cubes, or a maker that overflows.
The thermostat or thermistor tells the compressor when to run. A failed sensor makes the freezer run constantly or not at all, and the part is inexpensive compared with the compressor it protects.